*  	Verify no magnetic material (magnet)
*	Pierson/Vieira test on components (yank on them...)
*	Torque spec of : 
   	Divertor modules-
               Mother bolts     55 ft/lbs
               Sliding bolt     25 ft/lbs
   	Limiters- 
      		Beehive nut     15 ft/lbs 
	Antennas-
      		Moly tiles      22 ft/lbs
      		5/16 x 16       13 ft/lbs
                ¼ x 20           7 ft/lbs

*	Check various brackets for tight bolts/nuts

*	Cable tray cover plates secured (lift side ears to block nut) 
	- top 
	- down 

*	Verify glow discharge (not shorted) 
	- verify continuity with ohm-meter 
	- HI-POT  

*	verify Diborane 
	- check all tubes, and fittings (B) 

*	Remove unneeded T/C top (cut)  
	- verify underneath outer divertor 

*	Measure position of LH couplers in relation to LH Limiter 
*	- Top right/left corner gaps 
	- Bottom right/left corner gaps
      
*	Secure capillaries 
	- K bolo (main and ledge)
*	Secure telescopes 

*	Measure locations (radial) 
	- antennas 
	- limiters

*	Verify Thomson dumps and baffles

*	Check below/above and behind antennas

*	Operate shutters one last time 


*	Verify (black) dump for  
	- Z meter array (wall)(BC area) 
*	Others 

*	Digital camera survey 

*	Remove covers  
*	- vertical ports 
	- shutter (A) 
	- F (scanning probe cover) 
	- F poloidal view telescope (foil) 
	- tex wipes 

*	Final Vacuum