Cell Lockup and Pre-Run Checklist 
v102799 JHI 
Revised 02/18/05 GLD

. Check above, around, and below machine for following: 

. any tools left near machine 

. any large unsecured magnetic objects within a couple of feet 
of the igloo 

. objects such a ladders unsecured around machine or 
leaning on the igloo 

. cabling that is not properly secured 

. nitrogen leaks from boots 

. any large buildups of ice around the machine 

. heaters are all running and delivering heat to intended areas 

. heater hoses that have been removed from around ports

. check that YAG laser shutter is open 

. verify that cell exhaust fan is operational 

. RF 
. check SF6 and GN2 purge to RF components


SF6: 
D, E, and J 6" coax should be 17-20 psi 

J 9" coax should be 10-12 psi 

Record bottle pressure in OPS logbook

N2: 
D and E 9" coax (from stub tuner to 6" coax) should be 20 psi

D and E 9" coax (from switch to stub tuner) should be 2 psi 

. check that EFC front panel leds are in the proper state 

. in control room

. open bolometer shutter 


. enter vacuum and ECDC info in the computer logbook
 
******************************************************